J100H Flash file without dead risk by Gsm Dosctor Shohel 100% tested..

BY

 

How To Install Samsung J100H  4.4.4 Firmware

1. Boot your Samsung Galaxy  J1 SM J100H  into Download mode
   • Firstly, Switch off your phone.
   • Secondly, Press and hold “Home + Power + Volume down” buttons for a few seconds until you see a warning screen.
   • Thirdly, Press Volume Up on the warning screen to accept it and boot into Download mode.
2. Once your device is in download mode, connect it to the PC with a USB cable. The Odin window on PC should detect the phone and show an “Added!!” message.
3. Now, extract the .zipped Samsung Galaxy  J1 SM J100H  Firmware file you have downloaded to get the Odin flashable.tar file inside.
    Skip this step if you already have a .tar file of the Samsung SM J100H  Flash File.
4. Click on the AP tab on Odin window and select the .tar.md5 file from the Samsung Galaxy  J1 SM J100H  Firmware file that you have downloaded or can download it from the given below Link.
    Note: don’t play with any other options on the screen. Only you have to connect your Samsung Galaxy  J1 device and select the PA tab.
5. Click the Start button on Odin and wait for it to finish the process. Once it has finished successfully, you’ll see a pass message on the Odin screen.
6. Finally, the device will automatically reboot after Odin complete the flashing. Now disconnect your Samsung Galaxy  J1